Delphi SS12382 Engine Camshaft Position Sensor - Intake (Right)

Delphi SS12382 Camshaft Position Sensor

Delphi SS12382 is an engine camshaft position sensor built as a standard replacement for select Genesis, Hyundai, and Kia applications. It uses a 3-pin male terminal layout with a single oval male connector and black housing for a direct-fit style replacement where the vehicle calls for this sensor configuration.

Compatible with 2017-2023 Genesis G70, G80, and G90, plus 2017-2023 Hyundai and Kia applications listed below, this Delphi camshaft position sensor is calibrated to OE standards for accurate signal output. The SS12382 part number is also a useful reference when cross-checking interchange listings during diagnosis or repair.

Key Features

• Engine camshaft position sensor for ignition and engine management systems
• Standard replacement grade for select OE-style applications
• Black sensor body with 1 oval connector
• 3-pin male terminal design
• No wiring harness included
• Package contents: engine camshaft position sensor and instruction sheet
• Position-specific applications include Exhaust (Left), Intake (Left), and Intake (Right)

Detailed Description

Delphi SS12382 is engineered for vehicles that rely on precise camshaft position feedback for ignition timing and engine control. Delphi validates and calibrates its sensors to OE standards, helping deliver accurate readings that support consistent engine operation and reduce repeat repairs. This part cross-references Standard Ignition PC1183 for the same application.

Use the vehicle application data to confirm the correct position before ordering. For fitment-specific searches, this part is commonly referenced for a 2019-2023 Genesis G70 intake right camshaft position sensor, as well as related Genesis G80 and G90 applications and select Hyundai Palisade and Kia Telluride coverage. The SS12382 part number should be matched to the exact sensor location on the vehicle.

What It Helps Address

• Camshaft position sensor fault codes
• Rough idle or unstable engine operation related to timing signal loss
• Hard starting caused by incorrect camshaft signal input
• Intermittent stalling or drivability concerns tied to sensor output
• Check engine light conditions associated with camshaft position monitoring

Installation Notes and Tips

Confirm the sensor position on the engine before installation, since this part is used in Exhaust (Left), Intake (Left), and Intake (Right) locations depending on the application. Verify connector shape, terminal count, and connector gender against the original sensor, and inspect the harness connector for damage before installation. The package does not include a wiring harness.

Compatible With 2019-2023 Genesis G70, Intake (Right); 2020-2023 Hyundai Palisade, N/A; 2017-2022 Genesis G90, N/A; 2018-2022 Kia Stinger, Intake (Right); 2020-2022 Kia Telluride, N/A; 2019-2021 Kia Sedona, N/A; 2017-2020 Genesis G80, N/A; 2017-2020 Kia Cadenza, N/A; 2019-2020 Kia Sorento, N/A.

Quality Assurance

Delphi backs this sensor with OE development and product validation methods. Each sensor is tested and calibrated to OE standards to support accurate readings and consistent performance in the listed applications.