Delphi TA3499 Steering Tie Rod End - Front Left Outer

OE-Style Steering Tie Rod End

Delphi TA3499 is a front left outer steering tie rod end built for direct replacement service on select GM full-size trucks and SUVs. It combines OE-based dimensional analysis with material testing to support consistent steering response and proper fitment.

• Steering tie rod end for the front left outer position
• Pre-greased design with a dust boot included
• Steel housing and steel tie rod construction
• Bent design with threaded stud type
• Standard replacement grade for service repairs
• Mounting hardware included
• Black finish with rubber dust boot

Fitment and Application

Compatible with 2019-2024 Chevrolet Silverado 1500, front left outer; 2022 Chevrolet Silverado 1500 LTD, front left outer; 2021-2024 Chevrolet Tahoe, front left outer; 2021-2024 Chevrolet Escalade, front left outer; 2021-2024 Chevrolet Escalade ESV, front left outer; 2019-2024 GMC Sierra 1500, front left outer; 2022 GMC Sierra 1500 Limited, front left outer; 2021-2024 GMC Yukon, front left outer; and 2021-2024 GMC Yukon XL, front left outer.

Delphi TA3499 is engineered for vehicles that need a precise front left outer steering linkage replacement. This part number is listed for Chevrolet Silverado 1500 and GMC Sierra 1500 applications, along with Cadillac Escalade, Chevrolet Tahoe, and GMC Yukon models in the same steering position. This part cross-references Mevotech Supreme MS506138 and Mevotech TTX TXMS506138 for the same application.

Key Specifications

• Part number: TA3499
• Brand: Delphi
• Position: Front left outer
• End 1 gender: Female
• End 2 gender: Male
• End 1 and End 2 thread direction: Clockwise (right)
• Pre-greased: Yes
• Grease fitting included: No
• Dust boot included: Yes
• Housing material: Steel
• Tie rod material: Steel
• Adjustable: No

Common Repair Uses

• Restores steering linkage wear at the front left outer corner
• Addresses looseness or play in the steering system
• Replaces a damaged or corroded tie rod end
• Helps correct steering feel after suspension or front-end service
• Supports proper alignment retention after component replacement

Installation Notes and Tips

Confirm the front left outer position before installation and verify thread direction, stud dimensions, and overall length against the removed part. Because this is a non-adjustable tie rod end, alignment should be checked after installation to confirm steering wheel center and toe settings.

Quality Assurance

Delphi applies OE-focused engineering and dimensional analysis to its aftermarket steering parts. This tie rod end is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability in harsh conditions.