Delphi TA3508 Steering Tie Rod End - Front Outer

Delphi TA3508 Front Outer Tie Rod End

Delphi TA3508 is a steering tie rod end built for the front outer position on select Mercedes-Benz SUVs. It combines OE-based dimensional analysis with material testing to support accurate fitment and consistent steering response on the vehicles listed below.

• Front outer steering tie rod end for select Mercedes-Benz GLE450, GLE350, GLE580, GLS450, and GLS580 applications
• Standard replacement design with a straight body style
• Pre-greased and supplied with a dust boot
• Steel housing and steel tie rod material with a black finish
• Adjustable design with threaded stud construction
• Mounting hardware included
• End 1: female; End 2: male

OE-Based Steering Fitment

Delphi TA3508 is engineered for the front outer steering location and cross-references OE-style replacement numbers used on the same application, including Mercedes-Benz 167-330-71-00, Mevotech Supreme MS106236, and MOOG ES801679. It is listed for 2020-2022 Mercedes-Benz GLE450, 2020-2021 Mercedes-Benz GLE350, 2020-2021 Mercedes-Benz GLE580, 2020-2022 Mercedes-Benz GLS450, and 2020-2021 Mercedes-Benz GLS580. The Delphi TA3508 tie rod end uses a rubber dust boot, plastic bearing material, and right-hand thread direction on both ends for straightforward service replacement.

Common Repair Uses

• Restores worn or loose steering linkage at the front outer position
• Addresses steering play or imprecise road feel caused by tie rod end wear
• Replaces damaged dust boots or corroded steering components
• Supports proper front-end alignment after steering service
• Helps correct clunking or knocking from the outer steering linkage

Installation Notes

Verify vehicle year, model, and front outer position before installation. The part is adjustable and uses a threaded stud with hex head drive, so alignment should be checked after replacement. Delphi TA3508 is pre-greased and includes a dust boot, which helps simplify service on compatible Mercedes-Benz GLE450, GLE350, GLE580, GLS450, and GLS580 models.

Quality Assurance

Delphi applies OE-focused engineering to its aftermarket steering portfolio and validates parts through dimensional and material analysis. This tie rod end is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability in demanding conditions.