Delphi TA3673 Steering Tie Rod End - Front Inner

Delphi TA3673 Front Inner Tie Rod End

Delphi TA3673 is a straight steering tie rod end for the front inner position, built as a standard replacement for power steering systems. It features a steel housing, painted finish, pre-greased construction, and a clockwise right-hand thread for serviceable steering linkage replacement.

Key Features

• Front inner steering tie rod end
• Straight design with male threaded ends
• Clockwise (right) thread direction on both ends
• Steel housing with painted black finish
• Pre-greased for initial service readiness
• Adjustable design with locking nut included
• Standard replacement grade for OE-style service
• Compatible with power steering applications

Detailed Description

Delphi TA3673 is engineered for steering systems that require a front inner tie rod end with precise dimensional and material matching. Delphi applies OE-focused testing and analysis to its aftermarket steering portfolio, including exposure to extreme temperatures and extended salt-spray testing, to help maintain fit and durability in demanding road conditions. This part number, TA3673, is listed for 2017-2023 Jaguar F-Pace, 2019-2023 Jaguar I-Pace, and 2018-2023 Land Rover Range Rover Velar in the front inner position.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Loose or worn steering linkage at the front inner tie rod location
• Steering play or delayed response from a deteriorated tie rod end
• Uneven tire wear caused by steering geometry issues
• Clunking or knocking from worn steering components
• Restoration of proper toe adjustment retention after replacement

Installation Notes and Tips

Confirm thread direction, steering side, and front inner position before installation. TA3673 uses a threaded stud design and includes a locking nut, but does not include a grease fitting, dust boot, cotter pin, or mounting hardware. After installation, a professional wheel alignment is recommended to verify steering geometry and tire wear settings.

Quality Assurance

Delphi backs this steering component with OE-based engineering, dimensional analysis, and material validation to support consistent fit and performance. The part is tested for temperature extremes below -40 degrees C and above 120 degrees C, and for corrosion resistance through 720 hours of salt spray exposure.