Delphi TA6470 Steering Tie Rod End - Right Outer

Delphi TA6470 Right Outer Tie Rod End

Delphi TA6470 is a standard replacement steering tie rod end for the right outer position. It is built with a steel housing and steel tie rod, supplied pre-greased, and includes a rubber dust boot for added protection at the joint.

Compatible With 2014-2015 Kia Sorento and 2015-2021 Kia Sedona, this Delphi tie rod end is engineered using OE dimensional and material analysis to support proper fit and steering geometry. The TA6470 is a direct service part for right outer steering repair on these Kia applications.

• Part number: TA6470
• Position: Right outer
• Standard replacement steering tie rod end
• Steel housing and steel tie rod construction
• Pre-greased for initial service readiness
• Rubber dust boot included
• Mounting hardware included
• Male and female end configuration
• Clockwise (right) thread direction on both ends
• Non-adjustable, non-greaseable design

Detailed Product Information

Delphi applies OE-focused engineering to its aftermarket steering portfolio, and the TA6470 reflects that approach with dimensional and material matching intended to maintain compatibility with the original steering layout. The bent design, black finish, and standard replacement grade make it a practical service part for restoring steering linkage integrity on the Kia Sedona and Kia Sorento. This part cross-references Beck/Arnley 101-7941 for the same application.

Common Steering Issues This Part May Address

• Excessive play or looseness in the right front steering linkage
• Clunking or knocking from the outer tie rod area
• Uneven tire wear caused by worn steering components
• Steering wheel wander or reduced directional stability
• Visible damage to the dust boot or tie rod end joint

Installation Notes and Tips

Install TA6470 on the right outer steering position only. After replacement, have the vehicle inspected and the front-end alignment checked to confirm toe settings and steering wheel centering. Verify thread direction and end orientation before installation on 2014-2015 Kia Sorento and 2015-2021 Kia Sedona applications.

Quality Assurance

Delphi subjects steering components to OE-level validation, including extreme temperature exposure below -40 degrees C and above 120 degrees C, along with extended salt-spray testing. The brand also uses dimensional and material analysis to help ensure OE-to-aftermarket compatibility for the TA6470.