Delphi TAL10010 Alignment Cam Bolt Kit - Front

Front Alignment Cam Bolt Kit for Ford Trucks and SUVs

Delphi TAL10010 is a front alignment cam bolt kit built for vehicles that need precise suspension adjustment during wheel alignment service. It is a direct-fit hardware solution for select Ford F-150, Ford F-150 Lightning, Ford Expedition, Lincoln Navigator, and Lincoln Mark LT applications.

Engineered with Delphi OE-focused dimensional and material analysis, this kit is made to match the fit and function expected in front suspension alignment work. Delphi TAL10010 is a practical choice when restoring camber adjustment range on the front end.

Key Features

• Alignment cam bolt kit for front suspension service
• Adjustment type: cam bolt
• Adjustable angle design for alignment correction
• Nut included
• Grease fitting included
• Gray finish
• Bolt length: 6.85 in. (173.99 mm)
• Thread length: 2.90 in. (73.66 mm)
• Cam thickness: 0.18 in. (4.57 mm)

Detailed Description

Delphi TAL10010 is a front alignment cam bolt kit used to restore or fine-tune suspension alignment settings on select Ford and Lincoln platforms. It is listed for 2004-2023 Ford F-150 front, 2022-2023 Ford F-150 Lightning front, 2007-2017 Ford Expedition front, 2007-2017 Lincoln Navigator front, and 2006-2008 Lincoln Mark LT front. This part number, TAL10010, is built for alignment service where cam adjustment is required to help bring front suspension geometry back into specification.

This part cross-references Mevotech Supreme MS40004 and MOOG Chassis Products K100350 for the same application. Delphi applies OE-oriented testing and dimensional analysis to support fitment consistency across aftermarket steering and suspension service.

What It Helps Address

• Front wheel alignment that cannot be set within specification
• Camber adjustment needs after suspension service
• Front-end pull caused by incorrect alignment settings
• Tire wear related to misaligned front suspension geometry
• Replacement of worn or damaged alignment hardware

Installation Notes and Tips

Install Delphi TAL10010 on the front suspension only for the listed Ford and Lincoln applications. Verify vehicle year, model, and front-position fitment before installation, and follow the alignment procedure after hardware replacement. Because this is alignment hardware, a professional wheel alignment is recommended after installation to confirm cam settings and steering geometry.

Quality Assurance

Delphi subjects its OE-focused steering and suspension parts to extreme temperature testing below -40 degrees C and above 120 degrees C, along with 720 hours of salt spray exposure. These validation steps support durability expectations for front suspension service on Ford F-150, Ford Expedition, and Lincoln Navigator applications.