Delphi TC4224 Suspension Ball Joint - Front Lower Rearward

Delphi TC4224 Front Lower Rearward Ball Joint

Delphi TC4224 is a standard replacement suspension ball joint for the front lower rearward position on select Chrysler, Dodge, and related platforms. It is built with OE-focused dimensional and material analysis to support proper fit and consistent steering and suspension performance.

Key Features

• Part number: TC4224
• Standard replacement suspension ball joint
• Press-in mounting type
• Pre-greased for service-ready installation
• Rubber dust boot included
• Mounting hardware included
• Counterclockwise (left) thread direction
• Plastic bearing type
• Tapered stud with threaded stud design
• Power steering application

Fitment and Application

• Fits 2005-2023 Chrysler 300, front lower rearward
• Fits 2008-2023 Dodge Challenger, front lower rearward
• Fits 2006-2023 Dodge Charger, front lower rearward
• Fits 2005-2008 Dodge Magnum, front lower rearward

This part cross-references MOOG Chassis Products K80996 and Mevotech Supreme MS25505 for the same application. Delphi TC4224 is also listed against OE-style reference numbers used on Chrysler 300, Dodge Charger, Dodge Challenger, and Dodge Magnum front suspension service.

What It Helps Repair

• Front suspension looseness or play at the lower rearward control arm connection
• Clunking or knocking from worn ball joint components
• Uneven tire wear caused by excessive suspension movement
• Steering instability or wandering in the front end
• Restoration of proper joint articulation in the front lower suspension

Installation Notes

Delphi TC4224 uses a press-in mounting design and is specified for the front lower rearward position. Verify left-hand thread direction, stud taper dimensions, and vehicle application before installation. Because this ball joint is pre-greased and includes a dust boot, it arrives prepared for service, but the suspension should still be inspected for wear in adjacent components such as control arms, bushings, and tie rod ends.

Quality Assurance

Delphi applies OE engineering standards to its aftermarket steering and suspension range. This ball joint is tested for temperature extremes below -40 degrees C and above 120 degrees C, and it is exposed to 720 hours of salt spray to evaluate durability and corrosion resistance. Delphi also uses dimensional and material analysis to help maintain OE-to-aftermarket compatibility.