Delphi TC7011 Suspension Control Arm and Ball Joint Assembly - Rear

Rear Suspension Control Arm Assembly for Kia Sedona

Restore rear suspension geometry with this Delphi suspension control arm and ball joint assembly, part number TC7011. It is built for the rear position on the 2015-2021 Kia Sedona and combines OE-style materials, pre-greased components, and included bushings for a direct replacement service part.

• Fits 2015-2021 Kia Sedona, rear
• Delphi part number TC7011
• Control arm construction: casting/forged steel
• Ball joint included with press-in mounting type
• Pre-greased design with dust boot included
• Bushings included; rubber bushing material
• Mounting hardware and locking nut included
• Black painted finish with black bushings and boot
• Non-adjustable, power steering application

OE-Style Construction and Fit

Delphi applies OE-focused engineering to its aftermarket steering and suspension portfolio, using dimensional and material analysis to support proper fitment and consistent performance. This rear control arm assembly for the Kia Sedona uses steel construction, a threaded ball joint stud, chloroprene rubber dust boot material, and a premium-grade finish to match the demands of everyday suspension service. The TC7011 is a practical replacement for worn rear suspension components on the 2015-2021 Kia Sedona.

This part cross-references 55250A9000 and 1028342 for the same application.

Common Problems This Part Can Address

• Rear suspension looseness or clunking from worn ball joint or bushings
• Uneven tire wear caused by degraded rear control arm components
• Excessive rear-end movement over bumps or during cornering
• Noise from cracked, dry, or separated rubber bushings
• Loss of stable rear suspension alignment after component wear

Installation Notes and Tips

Verify rear position and vehicle application before installation. Because the ball joint is press-in and the assembly includes bushings and mounting hardware, replacement is typically performed as a complete unit rather than rebuilding individual wear parts. Confirm thread direction, stud engagement, and fastener torque against service specifications during installation.

Quality Assurance

Delphi subjects its OE-inspired steering and suspension parts to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure testing. That validation process helps support durability for rear suspension service on the Kia Sedona. Part number TC7011 is engineered with OE compatibility in mind for the listed fitment.