Dynamite Friction 4512-74111 Disc Brake Kit - Rear

Rear Brake Kit for Volkswagen Golf

Built for 2003-2006 Volkswagen Golf rear brake service, this DFC disc brake kit combines GEOSPEC coated rotors, 5000 Advanced ceramic pads, and matching hardware for a complete rear brake refresh. It is a direct-fit solution for vented rear rotor applications on the Volkswagen Golf and is designed to restore consistent braking performance with reduced noise and corrosion resistance.

Key Features

• Fits 2003-2006 Volkswagen Golf, rear
• Vented rear rotors for the listed application
• DFC GEOSPEC coated rotors with a silver-gray corrosion-resistant finish
• 5000 Advanced ceramic brake pads with post-cured friction material
• Scorched pad surface to reduce initial break-in time
• Rubber-steel-rubber shims for improved noise, vibration, and harshness control
• Hardware kit uses PTFE coating, vulcanized rubber, and stainless steel construction
• Part number 4512-74111

Product Details

The DFC GEOSPEC Coated Rotors with 5000 Advanced Brake Pads - Ceramic and Hardware package is engineered for rear brake service on the Volkswagen Golf. The rotors are machined to OE-style tolerances, finished with a non-directional surface for even pad bedding, and coated to help resist rust before installation. The pads are formulated for stable friction performance and are assembled with shims that help reduce brake noise and harshness. Part number 4512-74111 is a practical choice when replacing worn rear brake components on a 2003-2006 Volkswagen Golf.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Kit Can Address

• Rear brake noise during stops
• Uneven or premature pad wear
• Corrosion on exposed rotor surfaces
• Reduced braking smoothness from worn rear components
• Excessive caliper movement caused by fatigued hardware

Installation Notes and Tips

Use this kit for the rear axle only on the listed Volkswagen Golf applications. The rotors are shipped dry and ready to install, which helps reduce prep time during brake service. Inspect caliper condition, guide hardware, and brake fluid condition before reassembly, and follow the vehicle manufacturer’s service procedure for pad bedding after installation.

Quality Assurance

DFC states that each rotor is inspected for critical dimensions and balance, and the vented rotors are corrected if needed during the balancing process. The rotors carry a 12-month warranty against defects in material and workmanship.