Mevotech MB50322 Wheel Bearing and Hub Assembly - Front

Front Hub Bearing Assembly for Chevrolet Blazer

The Mevotech MB50322 is a front wheel bearing and hub assembly built for the 2019-2025 Chevrolet Blazer. It is a pre-greased Gen 3 hub assembly with a 6-stud wheel pattern and a 3-bolt flange design for direct replacement service on the front axle.

Mevotech Supreme Parts are engineered in-house with application-specific upgrades for durability and performance in passenger vehicles, SUVs, fleets, and working trucks. The MB50322 is part of that line and is built for demanding daily use on the Chevrolet Blazer front hub position.

• Part number: MB50322
• Front wheel bearing and hub assembly
• Fits 2019-2025 Chevrolet Blazer, front
• Gen 3 bearing generation
• Pre-greased for service-ready installation
• 6 wheel studs
• 3 flange bolt holes
• Inside diameter: 60.8 mm
• Outside diameter: 157.0 mm
• ABS sensor not included

Detailed Product Overview

Mevotech MB50322 is a front hub bearing assembly for Chevrolet Blazer models from 2019 through 2025. It is engineered for high-usage passenger and commercial duty, with a design focused on consistent wheel support and easier service. If you are replacing a worn front hub on a Chevrolet Blazer, MB50322 provides the correct hub assembly format for the front position.

This part cross-references MOOG Hub Assemblies 513449 for the same application. The MB50322 part number is also useful when searching for a Mevotech Supreme front wheel bearing and hub assembly for the Chevrolet Blazer.

Common Reasons for Replacement

• Front wheel bearing noise or growling
• Excessive play in the front hub assembly
• Uneven wheel rotation or rough bearing feel
• Hub wear from high-mileage driving
• Service replacement after front-end driveline wear

Installation Notes and Tips

Confirm front-position fitment before ordering and verify the 3-bolt flange and 6-stud hub configuration against the original part. The assembly is pre-greased, which helps streamline installation, and the ABS sensor is not included, so reuse or source the sensor separately if required by the vehicle setup. Always inspect the mating surfaces, fasteners, and surrounding suspension components during hub replacement.

Quality Assurance

Mevotech Supreme Parts are engineered in-house with application-specific upgrades for durability and performance. MB50322 is built for front hub service on the Chevrolet Blazer and is designed for demanding use in SUVs and working vehicles.