Mevotech MB60320 Wheel Bearing and Hub Assembly - Rear

Rear Wheel Bearing Hub for Honda CR-V

Mevotech MB60320 is a rear wheel bearing and hub assembly for the 2017-2023 Honda CR-V. It is built with a Gen 3 bearing design, comes pre-greased, and uses a 5-stud hub layout with 4 flange bolt holes for a direct rear service replacement.

Key Features

• Fits 2017-2023 Honda CR-V, rear
• Mevotech MB60320 wheel bearing and hub assembly
• Gen 3 bearing generation for modern hub service applications
• Pre-greased for ready-to-install service preparation
• 5 wheel studs and 4 flange bolt holes
• Outside diameter: 80.2 mm
• Anti-lock brake sensor not included

Detailed Product Overview

This rear hub assembly is intended for Honda CR-V rear wheel service where the bearing and hub are replaced as a unit. Mevotech MB60320 matches the 2017-2023 Honda CR-V rear application and is a practical OE-style replacement for vehicles needing a complete wheel bearing and hub assembly. This part cross-references MOOG Hub Assemblies 512633 for the same application.

Common Repair Uses

• Rear wheel bearing noise or roughness
• Hub play or looseness at the rear wheel
• Uneven wheel rotation caused by bearing wear
• Service replacement after hub corrosion or damage
• Restoring proper rear wheel support on a Honda CR-V

Installation Notes

Verify rear fitment before ordering and confirm the vehicle uses the correct 5-stud, 4-bolt flange configuration. The ABS sensor is not included, so reuse or source the sensor separately if required by the vehicle setup. Follow factory torque specifications and inspect the mating surfaces, axle area, and surrounding hardware during installation.

Quality Assurance

Mevotech supplies this hub assembly as a pre-greased Gen 3 unit for service-ready installation. The MB60320 part number should be matched to the vehicle application and rear position before installation.