Mevotech MB70305 Wheel Bearing and Hub Assembly - Front or Rear

Wheel Bearing Hub Assembly for VW and Audi

Mevotech MB70305 is a pre-greased wheel bearing and hub assembly for front and rear applications on select Audi and Volkswagen models. It is built with a Gen 3 bearing design, 5 wheel studs, and mounting hardware included for a direct replacement service on vehicles that use an 85mm bearing outside diameter.

Key Features

• Part number MB70305 wheel bearing and hub assembly
• Gen 3 bearing generation for modern hub service
• Pre-greased for installation-ready handling
• 5 wheel studs for the correct wheel mounting pattern
• 3 flange bolt holes
• Inside diameter: 30.3
• Outside diameter: 136.4
• Mounting hardware included
• ABS sensor not included

Fitment and Application

Compatible with select Audi A3, A3 Quattro, S3, TTS Quattro, TT RS Quattro, Q3, and A3 Sportback e-tron models, plus Volkswagen GTI, Jetta, Taos, Tiguan, Arteon, Golf, e-Golf, Golf Alltrack, Golf SportWagen, and Golf R applications that use an 85mm bearing outside diameter. Fits 2015-2025 Volkswagen GTI, rear; 2019-2025 Volkswagen Jetta, rear; 2022-2025 Volkswagen Taos, front; 2018-2024 Volkswagen Tiguan, front; 2019-2023 Volkswagen Arteon, front; 2015-2021 Volkswagen Golf, front; 2015-2020 Volkswagen e-Golf, front; 2017-2019 Volkswagen Golf Alltrack, front; 2017-2019 Volkswagen Golf SportWagen, front; 2015-2018 Volkswagen Golf R, front; 2019 Volkswagen Golf R, front; 2022-2025 Audi A3 Quattro, front; 2015-2020 Audi A3 Quattro, front; 2022-2025 Audi S3, front; 2015-2020 Audi S3, front; 2022-2023 Audi A3, front; 2015-2020 Audi A3, front; 2016-2023 Audi TTS Quattro, front; 2018-2022 Audi TT RS Quattro, rear; 2019-2021 Audi Q3, front; 2016-2018 Audi A3 Sportback e-tron, front.

This part cross-references Timken HA590608 and SKF BR930966 for the same application.

What This Part Helps Address

• Wheel bearing noise such as humming or growling from the hub area
• Excessive wheel play caused by hub wear
• Uneven wheel rotation from a worn bearing assembly
• Hub service needs on front or rear axle positions listed above
• Replacement of a damaged or corroded hub assembly

Installation Notes and Tips

Verify the vehicle’s bearing outside diameter and axle position before ordering. This assembly is listed for front and rear applications depending on model, and the ABS sensor is not included, so reuse or replace the sensor as required by the vehicle setup. Confirm wheel stud count, flange bolt hole quantity, and fitment notes for the exact Audi or Volkswagen application.

Quality Assurance

Mevotech MB70305 is a direct-fit hub assembly built around a Gen 3 bearing design and supplied pre-greased for service-ready installation. It is specified for select Audi and Volkswagen platforms that require an 85mm bearing outside diameter.