The Story
Rear Wheel Bearing Hub for Kia Sedona
Mevotech MB90303 is a rear wheel bearing and hub assembly built for 2002-2005 Kia Sedona models. It is a pre-greased, Gen 2 hub assembly with a non-integral ABS sensor and a 5-bolt, 143 mm outside diameter design for direct replacement service.
Key Features
- Fits 2002-2005 Kia Sedona, rear
- Mevotech Supreme Parts engineering with application-specific upgrades
- Pre-greased hub bearing assembly for service-ready installation
- Gen 2 design with non-integral ABS sensor
- 71 mm inside diameter and 143 mm outside diameter
- 5-bolt hole configuration
Product Details
MB90303 is part of Mevotech Supreme Parts, a line focused on upgraded replacement components for higher-demand passenger vehicles, SUVs, fleets, and working trucks. For the Kia Sedona rear hub application, this assembly is built to replace worn wheel bearings and hub units while maintaining the correct fitment and mounting dimensions. This part cross-references Timken HA590011 for the same application.
Common Problems This Part Can Address
- Rear wheel noise caused by a worn hub bearing assembly
- Excessive play or looseness at the rear wheel
- ABS-related service needs when the original sensor setup is non-integral
- Uneven hub wear from high-mileage daily driving
- Replacement needs on 2002-2005 Kia Sedona rear suspension service
Installation Notes
Confirm rear position, bolt pattern, and bearing dimensions before installation. Because this assembly is pre-greased, it arrives ready for bearing service, but proper torque procedures and clean mounting surfaces are still important for a correct repair. Verify ABS sensor configuration matches the vehicle’s original setup before final assembly.
Quality Assurance
Mevotech Supreme Parts are engineered in-house with application-specific design updates aimed at durability and performance in demanding use. MB90303 is built as a direct-fit replacement for the listed Kia Sedona rear application.
Description
Rear Wheel Bearing Hub for Kia Sedona
Mevotech MB90303 is a rear wheel bearing and hub assembly built for 2002-2005 Kia Sedona models. It is a pre-greased, Gen 2 hub assembly with a non-integral ABS sensor and a 5-bolt, 143 mm outside diameter design for direct replacement service.
Key Features
- Fits 2002-2005 Kia Sedona, rear
- Mevotech Supreme Parts engineering with application-specific upgrades
- Pre-greased hub bearing assembly for service-ready installation
- Gen 2 design with non-integral ABS sensor
- 71 mm inside diameter and 143 mm outside diameter
- 5-bolt hole configuration
Product Details
MB90303 is part of Mevotech Supreme Parts, a line focused on upgraded replacement components for higher-demand passenger vehicles, SUVs, fleets, and working trucks. For the Kia Sedona rear hub application, this assembly is built to replace worn wheel bearings and hub units while maintaining the correct fitment and mounting dimensions. This part cross-references Timken HA590011 for the same application.
Common Problems This Part Can Address
- Rear wheel noise caused by a worn hub bearing assembly
- Excessive play or looseness at the rear wheel
- ABS-related service needs when the original sensor setup is non-integral
- Uneven hub wear from high-mileage daily driving
- Replacement needs on 2002-2005 Kia Sedona rear suspension service
Installation Notes
Confirm rear position, bolt pattern, and bearing dimensions before installation. Because this assembly is pre-greased, it arrives ready for bearing service, but proper torque procedures and clean mounting surfaces are still important for a correct repair. Verify ABS sensor configuration matches the vehicle’s original setup before final assembly.
Quality Assurance
Mevotech Supreme Parts are engineered in-house with application-specific design updates aimed at durability and performance in demanding use. MB90303 is built as a direct-fit replacement for the listed Kia Sedona rear application.
