Mevotech MS500155 Alignment Toe Shim - Rear

Mevotech MS500155 Rear Toe Shim for Cruze Limited

Mevotech MS500155 is a full-contact alignment toe shim built for rear suspension adjustment. It uses a horseshoe shape with 4 bolt holes and a black finish, and it measures 5.3 inches in length with a maximum outside diameter of 5.3 inches and a maximum thickness of 0.05 inch.

Compatible With 2016 Chevrolet Cruze Limited, rear. This Mevotech toe shim is intended for precise rear toe correction on the listed application, and the part number MS500155 is also referenced for service identification.

Key Features

• Part number: MS500155
• Alignment toe shim for rear suspension adjustment
• Full-contact design for even seating
• Horseshoe shape with 4 bolt holes
• Black shim finish
• Shim length: 5.3 in.
• Maximum outside diameter: 5.3 in.
• Maximum thickness: 0.05 in.
• Adjustment type: Toe

Detailed Description

Mevotech MS500155 is a suspension hardware shim used to fine-tune rear toe settings on the 2016 Chevrolet Cruze Limited, rear. The full-contact construction helps the shim sit across the mating surface, while the horseshoe profile and 4-bolt-hole layout support alignment correction during service. If you are sourcing a rear toe shim for a 2016 Chevrolet Cruze Limited, MS500155 provides the specified dimensions and adjustment type for that application. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Issues It Can Address

• Rear toe angle out of specification after suspension service
• Uneven rear tire wear caused by toe misalignment
• Steering pull or tracking concerns related to rear alignment settings
• Need for small alignment correction without replacing major suspension components
• Post-repair alignment adjustment on the listed Cruze Limited application

Installation Notes and Tips

Install MS500155 during a proper alignment procedure and verify rear toe after assembly. Confirm the shim orientation, bolt-hole alignment, and mating surface condition before tightening fasteners. Because this is a precision alignment component, final settings should be checked with alignment equipment after installation.

Quality Assurance

Mevotech supplies suspension and steering service parts for professional repair use. MS500155 is built as a full-contact alignment shim for the specified rear application and should be verified against vehicle alignment requirements before service completion.