Sparta PN3165 Fuel Pump Module Assembly

Fuel Pump Module Assembly for Ford Focus

Restore dependable fuel delivery with the Sparta PN3165 fuel pump module assembly. This in-tank, specific-fit replacement is built for 2005-2007 Ford Focus models and includes the fuel sending unit, regulator, strainer, gasket/seal, and float arm for a complete service solution.

Sparta is distributed by Delphi, an OE fuel system supplier, and is aimed at higher-mileage and earlier model vehicles. The PN3165 is a standard replacement electric turbine pump assembly for gasoline applications, with a quick-connect outlet and a round female connector.

• Fits 2005-2007 Ford Focus
• Part number: PN3165
• In-tank electric fuel pump module assembly
• Fuel sending unit included
• Regulator included
• Strainer and nitrile rubber seal included
• Specific fit for direct replacement service
• Gasoline fuel system application
• Maximum pressure: 78 psi; minimum pressure: 60 psi
• Average current draw: 10 amps

Detailed Product Overview

The Sparta PN3165 fuel pump module assembly is engineered for Ford Focus fuel system service where a complete in-tank replacement is needed. It uses a turbine-style electric pump with a 13-volt design, one connector, four terminals, and a quick-connect outlet measuring 0.375 in. outside diameter. The assembly also includes the float arm and fuel level sending unit, helping maintain accurate fuel gauge operation after replacement. For shoppers searching for a 2005 Ford Focus fuel pump module assembly, 2006 Ford Focus fuel pump replacement, or 2007 Ford Focus in-tank fuel pump assembly, PN3165 matches the confirmed application.

This part cross-references Bosch 67273 and Airtex E2314 for the same application. The Sparta PN3165 is also referenced by 6S4Z 9H307-A and 953-4152 among other interchange numbers.

Common Problems This Part Addresses

• Hard starting caused by weak fuel pressure
• Engine stalling from inconsistent fuel delivery
• Fuel gauge inaccuracies from a worn sending unit
• Low-pressure or no-start conditions in the in-tank fuel system
• Fuel pump noise or reduced pump output on higher-mileage vehicles

Installation Notes and Tips

Install this module in the fuel tank and verify the round female connector, quick-connect outlet, and 4-terminal pin configuration before assembly. Replace the seal during service and confirm the tank opening is clean before seating the module. Because mounting hardware and lock ring are not included, reuse or source the required vehicle-specific retaining components as needed.

Quality Assurance

Sparta, distributed by Delphi, is positioned as an OE-informed fuel system brand for earlier model and higher-mileage vehicles. PN3165 is a standard replacement fuel pump module assembly built for direct-fit service on confirmed Ford Focus applications.